1. A. C. B. de Oliveira, M. Siami, and E. D. Sontag. Edge selections in bilinear dynamic networks. IEEE Transactions on Automatic Control, 69(1):331-338, 2024. [PDF] [doi:10.1109/TAC.2023.3269323] Keyword(s): bilinear systems, networks, robustness. Abstract:

   We develop some basic principles for the design and robustness analysis of a continuous-time bilinear dynamical network, where an attacker can manipulate the strength of the interconnections/edges between some of the agents/nodes. We formulate the edge protection optimization problem of picking a limited number of attack-free edges and minimizing the impact of the attack over the bilinear dynamical network. In particular, the H2-norm of bilinear systems is known to capture robustness and performance properties analogous to its linear counterpart and provides valuable insights for identifying which edges arem ost sensitive to attacks. The exact optimization problem is combinatorial in the number of edges, and brute-force approaches show poor scalability. However, we show that the H2-norm as a cost function is supermodular and, therefore, allows for efficient greedy approximations of the optimal solution. We illustrate and compare the effectiveness of our theoretical findings via numerical simulation

1. A. C. B. de Oliveira, M. Siami, and E. D. Sontag. Regularising numerical extremals along singular arcs: a Lie-theoretic approach. In , 2024. Note: Submitted.Keyword(s): optimal control, nonlinear control, Lie algebras, robotics. Abstract:

   Numerical ``direct'' approaches to time-optimal control often fail to find solutions that are singular in the sense of the Pontryagin Maximum Principle. These approaches behave better when searching for saturated (bang-bang) solutions. In previous work by one of the authors, singular solutions were theoretically shown to exist for the time-optimal problem for two-link manipulators under hard torque constraints. The theoretical results gave explicit formulas, based on Lie theory, for singular segments of trajectories, but the global structure of solutions remains unknown. In this work, we show how to effectively combine these theoretically found formulas with the use of general-purpose optimal control softwares. By using the explicit formula given by theory in the intervals where the numerical solution enters a singular arcs, we not only obtain an algebraic expression for the control in that interval, but we are also able to remove artifacts present in the numerical solution. In this way, the best features of numerical algorithms and theory complement each other and provide a better picture of the global optimal structure. We showcase the technique on a 2 degrees of freedom robotic arm example, and also propose a way of extending the analyzed method to robotic arms with higher degrees of freedom through partial feedback linearization, assuming the desired task can be mostly performed by a few of the degrees of freedom of the robot and imposing some prespecified trajectory on the remaining joints.

This material is presented to ensure timely dissemination of scholarly and technical work. Copyright and all rights therein are retained by authors or by other copyright holders.

This document was translated from BibT_EX by bibtex2html